KPS Throttle Spring Busa Gen3
Description
The original tension spring force of the GEN III Throttle Grip is much too forceful.
With this special spring your throttle grip will be much comfortable to use
As a result, the throttle grip pull is now the same to handle as the Busa Gen 1 and Gen 2.
Attention !!!
Installation Pictures shows only here !!!! and should only be done by a specialist / specialist workshop.
Installation instructions:
Remove left + right fairing parts
Remove plastic tank cover and lift tank up and support it with a suitable aid (tank support).
The sensor is located on the right side along the frame in front of the engine - just follow the Bowden cables.
There are 2 plugs and a hose in the way to unplug the sensor, unplug them and pull the hose out of the air filter box.
Now you can see the small plug from the sensor (color white) and disconnect it. Also the big long plug.
Unscrew the 2 retaining screws from the sensor and remove the complete sensor.
Remove the two Throttle cables.
Mark the sensor position (see picture with red color).
Loosen the fastening nut with spring washer of the tension spring holder and carefully remove the cover (Attention - is under tension due to the spring). If the cover is stuck, use 2 screwdrivers to slowly lever it out with feeling.
Remove old spring and insert new spring in same position (position pin is in base plate).
Please Note:
Also if you mess up the sensor position, remember you have acceleration percentage displayed on the dash. If you forgot about what direction, plug it in and see if you have full acceleration displayed or negative and the bike will not start. And adjust.
Hook the spring in the cover and insert it in the same position with pretension and skill.
Insert spring washer and tighten nut and secure with screw lock.
Reassemble in reverse order.
Check if all connectors are plugged together, if hose is in the air filter and if Throttle cables are free.
Installation Pictures shows only here !!!! not included with the Spring !!!
Made in Germany by certified spring factory.
Idea, development and tested by Turborider Team by KPS .
Installation also possible at KPS workshop.
Please Note:
Sometimes in different countries the shipping cost is higher then the Produkt. For secure shipping and both sides satifaktion - the produkt goes out with DHL insured Mail with internatinal Shipping Number you can Track. Please understand.
Australia Customers:
Please E-Mail me !!!!